Installation Steps
1. Slide off mounting plate in back of the light.
2. Install the mounting plate to the wall or mounting surface by using drywall screws (B).
If mounting to a wooden surface, drill three 3/32 in. holes into the mounting surface. Install the two mounting
screw, through the mounting plate and into the mounting surface.
If mounting to wall board or brick, drill three 7/32 in. holes into the mounting surface. Insert the wall anchors (A)
and attach the mounting plate using the three mounting screws.
3. Slide the light fixture back onto the mounting plate.
4. Place the solar panel to the wall and mark drilling location. Use an electrical drill (not included) to drill two holes
into the mounting surface. Then install the solar panel the same way as the mounting plate to the wall using
drywall screws (B) with or without anchors (A). (See Fig.1)
Note: The solar panel is equipped with a 16ft. (5M) connecting wire, so the light fixture and solar panel
can be installed up to 16ft. (5M) apart.
5. Connect the cable from solar panel to the bottom of light panel to the bottom of light fixture. Only use the included
solar panel to charge the light, any other external charger may damage the light fixture. (See Fig.2)
Page 2 / 5
C
Fig.3
Adjusting the Sensor Head (C):
1. Aim sensor head toward desired detection area, maintaining a 5° - 40° downward
angle to allow moisture to drain.
Note: Make sure sensor head is positioned with controls facing toward the ground.
2. You can rotate the sensor head up and down to change the coverage area.
(See Fig.3)
Note: Range set too high may increase false triggering.
(See Fig.4 and Fig.5)
Sensor Adjustment Higher For Long Coverage
Sensor Adjustment Lower For Short Coverage
Fig.4
Fig.5
Sensitivity of Motion Sensor
(See Fig.10)
Adjusting the Light Head (B):
1. Adjust the light head up or down, left or right for desired area.
Keep the light heads at least 1" (25mm) away from the sensor.
(See Fig.6)
2. Keep the light heads (B) face down around 30 degrees angle
to avoid water damage.
You can adjust the sensitivity of the motion sensor by using the
"SENS" selector located on the right side of the sensor head.
Adjust motion sensor sensitivity to HIGH (H), MEDIUM (M),
or LOW (L) to achieve desired performance.
Approximate range for each setting: 50 ft. (H), 32 ft. (M), 16 ft (L).
For eave mounted only:
Swing the sensor head towards the mounting surface.
Rotate the sensor head unclockwise 180˚ so the controls face down.
Backplate
Controls
Controls
Controls
Fig.6
231130
