Turn on the power at fuse or circuit box.
Turn off the power at fuse or circuit box
Installation Steps
The Position of Control Panel
Page 2 / 5
1. Unscrew the two bolt nuts (D), remove the two rubber pads (E) and the cross bar unit (A) from the backplate.
2. Attach the cross bar unit (A) to the outlet box by using two mounting screws (B). Adjust the length of the preinstalled
headless screws if necessary.
Note: Make sure that the headless screws are lined up horizontally to make the fixture level.
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:
• Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
• Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
• Attach the fixture ground wire (usually green insulation or bare wire) to the cross bar unit (A) with the
green ground screw. Then, depending on local code, then connect it to the house ground wire with the
wire connector (C).
Carefully put all of the wires back into the outlet box.
4. Attach the backplate of the fixture to the cross bar unit (A) by inserting headless screws into set holes on the
backplate, then secure it with two rubber pads (E) and two bolt nuts (D).
Note: With silicone caulk compound, caulk completely around where the backplate meets with the wall
surface to prevent water from seeping into the outlet box.
5. Install the bulb (not included). Check relamping label at socket area or packaging for maximum wattage allowed.
Adjustable
Knob
View Fig.A
Fig.2
Sensor
Lens
Fig.1
Fig.3
Fig.A
“TIME” Knob
“LOW LEVEL” Knob
“SENS” Knob
Small Slotted Screwdriver
(not included)
Slide Switch
TIME
LOW LEVEL
SENS
TEST
OFF
AUTO
PC
Step 1: Rotate the sensor lens from left side to right side
to show the adjustable knobs and slide switch.
(See Fig.1)
Step 2: Adjust time, low level brightness and sensitivity by
turning the knobs and choose the mode you want
by sliding the switch. (See Fig.2 and Fig A).
Step 3: Restore the sensor lens to original position by
rotating the lens from the right side to the left.
(See Fig.3)
220720
Sensor
Lens
