IMPORTANT:
FUNCTION:
The fixture features a photocell sensor which enables the light to turn on at dusk and off at
dawn automatically.
Turn off the power at fuse or circuit box.
180408
Page 2 / 3
1.
Install the mounting strap to the outlet box with the stamped word “FRONT” facing away from the outlet box, using two
mounting screws that best fit the outlet box. Back plate should sit flush against wall surface when secured.
(Choose one matching pair of suitable mounting screws from the 3 pairs provided)
2. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows:
---Connect the black wire from the fixture to the black wire from the power source
(usually black)
.
---Connect the white wire from the fixture to the white wire from the power source
(usually white)
.
Carefully tuck the wires back into the outlet box.
3.
Attach the back plate of the light to the mounting strap, secure it with the fixture mounting screw.
4.
Push the decorative cover firmly into the fixture mounting screw hole on
the light.
5.
With silicone caulking compound, caulk completely around where the back
plate meets the wall surface.
CAUTION: Be sure to caulk completely where the back plate meets
the wall surface to prevent water from seeping into the outlet box.
Manual Override Mode (nighttime operation only)
●
To temporarily override the settings in “ 100% Brightness ”,
100% Brightness modes switch to manual override, turn the
wall switch “OFF” then turn it “ON” twice within 3 seconds.
switch to low level. To shift back to “ 100% Brightness
mode”, turn the wall switch “OFF” then turn it “ON” twice
within 3 seconds again.
●
The light turns off automatically at dawn. ( See Fig.1 )
FRONT
Mounting Strap
Outlet Box
Wire Connector
Back Plate
Mounting Screw
Light Head
Photocell
Fixture Mounting Screw
Decorative cover
Light fixture should be mounted as shown above when installed (depending upon type of installation)
Installation Steps
100% Brightness
( low-level and
high-level ) Mode
Manual
Override
Manual Override Operation Diagram
Turn wall switch OFF-ON
-OFF-ON in 0.5~3
Seconds
Turn wall switch OFF-ON
-OFF-ON in 0.5~3 Seconds
Fig. 1
