181010
C
B
A
4. Attach the fixture to the cross bar (A) by inserting headless screws (D) into holes on back plate, and then secure
it with two rubber pads (H) and two ball nuts (G).
Note: With silicone caulking compound, caulk completely around where the back plate meets with the wall
surface to preface to prevent water from seeping into outlet box.
5. Attach the shade to the socket, and then secure it with the socket ring.
6. Install a bulb (not included). Check relamping label at socket area or packaging for maximum allowed wattage.
Turn on the power at fuse or circuit box.
Turn on the power at fuse or circuit box.
A: 12"
B: 9"
C: 14"
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Assembly Kit
5486MM (1 SET) for T0350
5993MM (1 SET) for T0494
1. Turn off the power at the fuse or circuit box before starting installation.
2. Loosen the wire connectors connected with the wires from photocell. (See Fig.1)
Note: Do not move the photocell to prevent water from seeping into the outlet box.
3. Take a white pigtail and black pigtail and make wire connections using wire connectors (F): (See Fig.2)
a. The black wire from the fixture to one end of the black pigtail.
b. The white wire from the fixture to one end of the white pigtail.
c. The other end of the black pigtail to the black wire from the power source.
d. The other end of the white pigtail to the white wire from the power source.
Put all wires back into the back plate of the fixture.
Photocell
White
W
ires From Photocell
Wire Connector
Wires From Fixture
Wires From Fixture
Wires From
Main Power
Wire Connector (F)
White Pigtail
Pigtail
Red Wires From Photocell
Black W
ires From Photocell
Operation the Unit Without Photocell
Fig.1
Fig.2
Mounting Screw (B)
Wire Connector (F)
Ball Nut (G)
Rubber Pad (H)
Cross Bar (A)
Green Grounding
Screw (C)
Lock Nut (E)
Headless Screw (D)
