FT-270 Monteros in Basin Fountain
Professional installation is recommended for this fountain! Assemble your fountain on a level surface using crushed stone, gravel, or
cement pad as the base.
Revised August 28, 2017
- W I N T E R C A R E -
Fountain bowls/tops and other fountain components, which collect water, should not be left outside in the winter since any component,
which fills with water and freezes may crack. Likewise components such as pedestals, which remain in a basin, filled with water,
which then freezes, may also crack or crumble. Ideally, therefore, a fountain should always be stored indoors or in a dry protected
place such as a covered porch away from the elements. However, if a fountain must be left outside:
(1) Remove pump, rubber stoppers, drainpipes, finials, and other small components for storage indoors. Note that stoppers or
drainpipes are removed to allow drainage in the event water accumulates in any basin.
(2) Raise fountain base from ground with wood strips so that base will not freeze to the ground surface.
(3) Cover or wrap the fountain with burlap or other absorbent material (old blanket or towel) and then cover securely with
plastic, making sure that water will not accumulate in the basin or other fountain component and freeze;
(4) Check fountain periodically to insure that plastic is secure and water is not accumulating in any fountain component.
- G E N E R A L F O U N T A I N T I P S -
Install fountains on a level surface.
You will need a properly grounded 110-volt (AC only) GFCI protected receptacle near the
fountain for your pump. All pumps are submersible and must be completely underwater to function properly. Test all pumps and
adjust to full output prior to assembly. It is not recommended that fountains be placed directly on grass or dirt. Position the channel
opening at the base of each fountain toward the electrical outlet to be used since the pump
cord will be threaded through this opening.
Check out YouTube for a “How to” video. (https://youtu.be/O1AadJ99W24)
For more Campania product information visit www.campaniainternational.com
All of our cast stone is proudly
Pump Kit Parts List
PK800 pump (2)
#10 stopper with double hole (1)
Metal plug for hole in side of basin (already installed in basin) (1)
2.8 oz tube of silicone (1)
2” length of 3/4” Clear Vinyl tubing (2) **
2” length of 5/8” Clear Vinyl tubing (2) **
Approx. 72” length of 1/2” Black Non-Kink tubing (2) **
Approx. 18” length of 1/2” Black Non-Kink tubing (1)
13.5” length of 1 ½” PVC “Stand Pipe” (1)
Rubber band (1)
#7 Drain Stopper w/ Wing Nut (2)
Wedges (22)
Hose clamps (5) *
Wood Spacers for installation (8)
* Hose clamps may be used as flow restrictors
**Tubing is preassembled
FOUNTAIN INFORMATION:
This fountain holds approximately 240 gallons of water.
This fountain uses a medium fountain cover but does
not cover the basin.
(FTNCOV-MED)
Compatible with Refill #10 Device and LED kit
(A different style stopper may be requested for the refill kit.)
TOOLS REQUIRED:
Bubble Level
Tape Measure
PUMP INFORMATION:
OEMPP800 - 800 GPH Pump
16 FT cord length
