FT-270 Monteros in Basin Fountain
Professional installation is recommended for this fountain! Assemble your fountain on a level surface using crushed stone, gravel, or
cement pad as the base.
Revised August 28, 2017
FGB-2020 (260 lbs)
90”W x 10”H
FT-269H (392 lbs)
24”L x 24”W x 15”H
P-711 (535 lbs)
47”W x 26”H
FT-269F (103 lbs)
13.5”W x 18”H
FT-269E (94 lbs)
29”W x 9.5”H
FT-269C (35 lbs)
9.25”W x 14”H
1.
Place the fiberglass basin where the fountain is to be installed.
a.
Be sure to check that each part is level and centered during the assembly of
this fountain.
2.
Spread a thin amount of silicone on both pump cords approximately 3 feet from the
pumps and fit them into the double holed stopper.
3.
Feed the pump cords through the hole in the basin.
4.
To ensure a level installation, make sure that you run the remaining cord through the
channel in the bottom of the basin.
5.
Press stopper firmly and evenly into the hole of basin.
6.
Spread a thin bead of silicone around the perimeter of the stopper, slit in the stopper,
and around the pump cords.
7.
Loosely wrap cords up in the center of the basin.
8.
Place the fountain base (FT-269H) over the pumps and the cords.
9.
Place the urn (P-711) on top of the base (FT-269H).
10.
Place the standpipe inside the hole of the urn.
11.
Insert both 72” lengths of 1/2” non-kink tubing through the pipe onto the bottom of the
base. Make sure to feed the end with the assembled clear vinyl tubing down into the
basin.
12.
Connect the clear vinyl tubing onto the pump water outlets of the pumps.
13.
Fold the end of one of the lengths of tubing down over the edge of the standpipe.
14.
Secure the tubing by placing the rubber band over the tubing and pipe so that the
tubing opening points down into the bowl.
15.
Insert the remaining tubing coming out of the standpipe up through the pedestal (FT-
269F) and place the pedestal over the standpipe in the center of the urn.
16.
Place a hose clamp over the top end of the tubing and connect that end of the tubing to
the bottom of the middle bowl (FT-269E). Tighten the hose clamp to ensure a good
seal.
17.
Place the middle bowl down onto the middle pedestal.
18.
Place a hose clamp over one end of the 18” length of 1/2” non-kink tubing.
19.
Connect that end of the tubing to the pipe protruding out from the top of the middle
bowl (FT-269E). Tighten the hose clamp to ensure a good seal.
20.
Feed the other end of the tubing up through the small pedestal (FT-269C) while
lowering the pedestal down into the middle bowl (FT-269E).
