Page 4 / 5
180704
10'
8.0'
12.0'
70'
Notes:
1. The sensitivity of the motion sensor will increase as the
environmental temperature gets cooler. For best
performance, gently clean the lens with a soft cloth every
1 or 2 months to ensure maximum sensitivity.
2. For best performance, install fixture at least 8 feet above
the ground. At such a height, the fixture will provide a
detection distance of up to 70 feet at 77 degrees
Fahrenheit. (See Fig.7)
3. The sensor detects movement across a detection range
of 180 degrees. (See Fig.8)
4. The sensor will be more sensitive to motion across its
detection path than motion directly towards it. (See Fig.9)
5. To reduce possible nuisances, do not mount the fixture
near a heat source like an air conditioner, vent or furnace
exhaust, or in a direction facing any reflective object or
other nearby light source.
Where you install your fixture is important:
Be sure the light is mounted straight on the wall
or eave; otherwise, the detection distance may
be limited.
Shut-off Delay
●The shut-off delay is the length of time the light will stay at full brightness after motion
is detected.
●You can set the shut-off delay by rotating the Time knob arrow so it points to the desired time setting (from 5
seconds to 3 minutes). To increase the shut-off delay, turn the knob clockwise. To decrease the shut-off delay,
turn the knob counterclockwise.
Customization Options:
Fig. 7
Fig. 8
Motion
Least sensitive
Motion
Most sensitive
Sensor
Fig. 9
180˚
“OFF” or
“AUTO” Mode
Manual
Override
Manual Override Operation Diagram
Turn wall switch OFF-ON
in 0.5~3 Seconds
Turn wall switch OFF-ON
in 0.5~3 Seconds
Fig. 6
5. Manual Override mode (nighttime operation only)
● To temporarily override the settings in “OFF” or “AUTO”
modes for continuous full-brightness at night, turn the wall
switch “OFF” then turn it “ON” within 3 seconds. The light
r
emains on all night long. To shift back to “OFF” or “AUTO”
mode, turn the wall switch “OFF” then turn it “ON” within 3
seconds again.
●
The light turns off automatically at dawn.
Note: To make sure the above functions operate properly,
always keep the wall switch in the “ON” position (including
the daytime).
