Page 3 / 5
Function and Operation
Choose a mode by sliding the switch on the bottom of the sensor. (See Fig.4)
Note: When power is first applied, the light will turn on . The sensor will take 30 seconds to warm up.
1. Test mode(daytime or nighttime operation
）
●
Rotate knob on the bottom of the sensor to the “TEST” position. (See Fig.4)
● When slide the mode selector to “OFF”, the light turns off automatically. It turns to high-level brightness when
motion is detected, and stays on as long as the motion continues. It turns off about 5 seconds after motion
is no longer detected.
● When slide the mode selector to “AUTO”, the light turns to low-level brightness automatically. It turns to
high-level brightness when motion is detected, and stays on as long as the motion continues. Then reverts
back to low-level brightness about 5 seconds after motion is no longer detected.
● When slide the mode selector to “PC”,
the light will turn off when it is daytime, if it is nighttime, the light will turn
to high-level brightness.
2. OFF MODE (nighttime operation only)
● To shift to
“OFF” mode, rotate Time knob arrow to point to the desired time setting (between 5 seconds and 3
minutes). At dusk, the light turns to high-level brightness automatically when motion is detected, and stays on as
long as the motion continues. When the motion is no longer detected, the light at full brightness remains on for
the predetermined time you set (5s ~ 3min), after then the light turns off automatically.
● The light turns off automatically at dawn.
3. AUTO MODE (nighttime operation only)
● To shift to “AUTO” mode, rotate Time knob arrow to point to the desired time setting (between 5
seconds
and 3 minutes). At dusk, the light turns on to low level brightness. When motion is detected, the light turns to
full brightness and stays on as long as motion continues. When the motion is no longer detected, the light at
full brightness remains on for the predetermined time you set (5s ~ 3min), and then switches back to low level
automatically.
● The light turns off automatically at dawn.
4. PC MODE (nighttime operation only)
● The light turns on to full brightness at dusk and remains on until dawn.
Fig. 4
Fig. 5
Sensitivity of Motion Sensor
● You can adjust the sensitivity of the motion sensor by using the “SENSITIVITY” selector located on the right side
of the bottom surface of the sensor. (See Fig. 4)
● Adjust motion sensor sensitivity to achieve desired performance.
● Approximate range for each setting from 10ft to 70ft.
Adjusting the Light Head:
1. Gently grasp the light heads and move them up or down, left or right to adjust the light coverage area. Keep the light
heads at least 1” (25mm) away from the sensor.(See Fig. 5)
2.
Keep the light heads 30˚ below horizontal to avoid water damage and electrical shock.
Light Head
3MIN
OFF
A
U
TO
SENSITIVITY
TIME MODE
5S
TEST
PC
180704
