Page 4 / 5
150623
Notes:
1. The sensitivity of the motion sensor will increase as the environmental temperature gets cooler. For best
performance, gently clean the lens with a soft cloth every 1 or 2 months to ensure maximum sensitivity.
2. For best performance, install fixture at least 8 feet above the ground. At such a height, the fixture will provide a
detection distance of up to 70 feet at 77 degrees Fahrenheit. (See Fig.6)
3. The sensor detects movement across a detection range of 240 degrees. (See Fig.7)
4. The sensor will be more sensitive to motion across its detection path than motion directly towards it. (See Fig.8)
5. To reduce possible nuisances, do not mount the fixture near a heat source like an air conditioner, vent or furnace
exhaust, or in a direction facing any reflective object or other nearby light source.
Customization Options:
Shut-off Delay
● The shut-off delay is the length of time the light will stay at
full brightness after motion is detected.
● You can set the shut-off delay by rotating the Time knob arrow so it points to the desired time setting (from 5
seconds to 3 minutes). To increase the shut-off delay, turn the knob clockwise. To decrease the shut-off delay,
turn the knob counterclockwise.
3.
3 HOUR MODE (nighttime operation only)
● To shift to the “3H” mode,
place the slide switch to “3H” position, and rotate Time knob arrow to the desired time
setting (between 5 seconds and 3 minutes). At dusk, the light turns to low level brightness automatically. From
this moment on, it will remain on for 3 hours. During this 3 hours, when motion is detected, it turns to high level
brightness, and stays on as long as motion continues. When the motion is no longer detected, it remains high
level brightness for the predetermined time you set (5s ~ 3min), and then turns to low level brightness
automatically. After the 3 hours, it turns off. when motion is detected again, it turns to high level brightness, and
stays on as long as motion continues. When the motion is no longer detected, it turns off after the predetermined
time you set (5s ~ 3min).
● The light turn
s off automatically at dawn.
4.
6 HOUR MODE (nighttime operation only)
● To shift to the “6H” mode,
place the slide switch to “6H” position, and rotate Time knob arrow to the desired time
setting (between 5 seconds and 3 minutes). At dusk, the light turns to low level brightness automatically. From
this moment on, it will remain on for 6 hours. During this 6 hours, when motion is detected, it turns to high level
brightness, and stays on as long as motion continues. When the motion is no longer detected, it remains high
level brightness for the predetermined time you set (5s ~ 3min), and then turns to low level brightness
automatically. After the 6 hours, it turns off. when motion is detected again, it turns to high level brightness, and
stays on as long as motion continues. When the motion is no longer detected, it turns off after the predetermined
time you set (5s ~ 3min).
● The light turns off automatically at dawn.
5. D2D MODE (
nighttime operation only)
● To shift to the “D2D” mode,
slide switch to “D2D” position, and rotate Time knob arrow to the desired time setting
(between 5 seconds and 3 minutes). At dusk, the light turns to low level brightness automatically, it turns to high
level brightness when motion is detected, and stays on as long as motion continues. When the motion is no
longer detected, it remains on for the predetermined time you set (5s ~ 3min), and then switch back to low level
brightness.
● The light turns off automatically at dawn.
Note: To make sure the above functions operate properly, always keep the wall switch in the “ON” position
(including the daytime).
