T0103 --- Page 4 / 5
140919
20'
8.0'
12.0'
70'
Notes:
1. The sensitivity of the motion sensor will increase as the
environmental temperature gets cooler. You may wish to
make adjustments when the season changes.
For best performance, gently clean the lens with a soft
cloth every 1 or 2 months to assure maximum sensitivity.
2. For best performance, install fixture at least 8 feet above
the ground. At such a height, the fixture will provide a
detection distance of up to 70 feet at 77 degrees
Fahrenheit. (See Fig.9)
3. The sensor detects movement across a detection range
of 360 degrees. (See Fig.10)
Where you install your fixture is important:
Be sure the light is mounted straight on the wall
or eave; otherwise, the detection distance may
be limited.
Shut-off Delay
Customization Options:
The shut-off delay is the length of time the light will stay at brightness after motion has ceased to be detected.
You can set the shut-off delay by rotating the delay time knob arrow so it points to the desired time setting within
“TIME” range. To increase the shut-off delay, turn the knob clockwise. To decrease the shut-off delay, turn the
knob counterclockwise.
Fig. 9
Fig. 10
“AUTO” “3H”
or “6H” Mode
Manual
Override
Manual Override Operation Diagram
Turn wall switch OFF-ON
-OFF-ON in 0.5~3
Seconds
Turn wall switch OFF-ON
-OFF-ON in 0.5~3 Seconds
Fig. 8
3. 6 HOURS (6H) MODE (nighttime operation only)
The light will turn to high-level brightness (100%) at dusk, and will stay "ON" for 6 hours. The light will then
turn to low-level brightness. The light will turn to high-level brightness (100%) when motion is detected, and
will stay on as long as motion continues. When motion is no longer detected, the lights will remain on for the
predetermined shut-off delay time you set (5~180 seconds), and then turn to the predetermined low-level
brightness automatically.
The light will turn off automatically at dawn.
Note: You can adjust the low level brightness (0~50%) by using the low level brightness knob. (See Fig. 7)
4. PHOTOCELL (PC) MODE (nighttime operation only)
The light will brighten at dusk. It will turn off at dawn.
5. Manual Override (nighttime operation only)
To shift to the manual override mode, set the mode selector
to “AUTO”, “3H” or “6H” mode. Turn the wall switch “OFF”,
and turn it “ON” twice within 3 seconds. The light will remain
on all night long. To shift back to “AUTO”, “3H” or “6H”
mode, turn the wall switch “OFF”, and turn it “ON” twice
within 3 seconds again.
The light will turn off automatically at dawn.
Note: To make sure the above functions operate properly, always keep the wall switch in the “ON” position (including
the daytime).
360
˚
Motion
Least sensitive
Motion
Most sensitive
Sensor
4. The sensor will be more sensitive to motion across its
detection path than motion directly towards it. (See Fig.11)
5. To reduce possible nuisances, do not mount the fixture
near a heat source like an air conditioner, vent or furnace
exhaust, or in a direction facing any reflecting object or
other light source.
Fig. 11
