Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
●
Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
●
Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
●
All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
●
Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
●
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
PREPARATION
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
Page 2 of 3
180806
SAFETY INFORMATION
ASSEMBLY INSTRUCTIONS
1. Thread two headless screws (CC)
through the cross bar (AA), and
then secure them with four lock
nuts (EE) (two on each side of the
cross bar (AA). Adjust the length of
the headless screws (CC) if
necessary.
Note: Make sure that the
Headless screws are lined up
horizontally to make the fixture
level.
AA
EE
CC
1
2. Attach cross bar(AA) to outlet box
using two mounting screws(BB).
4. Screw one end of the threaded
pipe into the coupling, secure it
with the washer and hex nut.
Adjust the length of the
threaded pipe by using the hex
nut if necessary. Attach the tail
and pipe cap through the
threaded pipe, then secure
them with the finial.
Coupling
Pipe Cap
Tail
Finial
Hex Nut
Threaded Pipe
Washer
4
3. Pull out the source wires from the
outlet box. Make wire connections
using wire connectors (DD) as
follows:
• Connect the hot wire (usually
black insulation) from the fixture
to the black wire from the power source.
• Connect the neutral wire (usually white insulation)
from the fixture to the white wire from the power
source.
• Attach the fixture grounding wire (usually green
insulation or bare wire) to the cross bar (AA) with
the green grounding screw (HH), and then connect it
to the house grounding wire with the wire connector
(DD).
Carefully put all of the wires back into the outlet box.
DD
AA
3
Turn off the power at fuse or circuit box.
2
AA
BB
