9
9. Troubleshooting
WARNING: TO REDUCE RISK OF PERSONAL INJURY, UNPLUG VACUUM CLEANER BEFORE
SERVICING
PROBLEM: Cleaner won’t run
Cause:
Not properly plugged into electrical outlet.
Solution:
Plug in firmly.
Cause:
No electricity in electrical outlet.
Solution:
Check fuse or breaker.
Cause:
On/off switch not turned on.
Solution:
Push on/off switch to on.
Cause:
Motor thermostat tripped.
Solution:
Reset motor thermostat (see page 3).
Cause:
Blown fuse/tripped breaker.
Solution:
Reset circuit breaker or replace fuse.
PROBLEM: Cleaner won't pick up
Cause:
Full or clogged dirt container.
Solution:
Clean dirt container.
Cause:
Wrong pile height setting.
Solution:
Adjust brushbar height adjust.
Cause:
Clogged nozzle.
Solution:
Remove obstruction.
Cause:
Clogged dirt inlet.
Solution:
Remove power head cover and remove obstruction.
Cause:
Clogged hose.
Solution:
Remove obstruction.
Cause:
Broken belt.
Solution:
Replace belt.
Cause:
Hose not inserted fully.
Solution:
Push hose in securely.
Cause:
Dirty filters.
Solution:
Clean/change filters.
Cause:
TurboTool
®
is not installed properly and/or blocked (X-003T only)
Solution:
Check for blockages and check that the locking ring is correctly returned to position
PROBLEM: Accessories won't pick up
Cause:
Accessories not attached correctly.
Solution:
Refer to page 6 for fitting information.
PROBLEM: Cleaner picks up moveable rugs or pushes too hard
Cause:
Wrong pile height setting.
Solution:
Adjust setting on brushbar height adjust.
Troubleshooting
X-003 D2.1.qxd 9/9/05 11:14 AM Page 9