5
Vax Careline
0870 606 1248
assembly
Position hose over rack (A) and into hose tube (B)
(Fig.3/8).
NOTE: Hose must be connected at the hose tube and
at the dirt duct on the back of the cleaner for carpet
or floor cleaning. For tool use, refer to next chapter.
Attach Handle
NOTE: DO NOT remove orange tie wrap until the next
step is complete.
Grasp orange tie wrap (A) and pull until the black plug (B)
comes out of the handle cavity (Fig.3/9).
Hold plug (B) with one hand; upper handle (C) with other
hand. Push plug into upper handle, aligning with opposite
end of plug and push firmly
UNTIL YOU HEAR A SNAP
OR A CLICK
(Fig.3/10).
After ends are connected, pull on plug to make sure it is
securely attached.
NOTE: The plug will only fit together one way. If plug
is not fitting together, check alignment of ends. After
the plug ends are fully connected, the orange tie
wrap must be removed. Use caution so as NOT TO
CUT the black power cord. Discard the orange tie
wrap.
Align the groove on the back of the upper handle with
the small projectionon the back of the handle housing
(Fig.3/11).
Press button at handle base and push handle all the way
down (Fig.3/12).
Fig.3/7
Fig.3/8
Push firmly
until you hear a
snap or click
Fig.3/10
Fig.3/11
Fig.3/12
Fig.3/9
A
A
A
B
B
B
