www.vax.co.uk
10
maintenance
Grasp brush bar firmly and fit it into position by first
sliding end opposite the belt into the rectangular slot (A)
on side of cleaner.
Pull other side of brush bar (B) into place (Fig.6/7).
Turn brush bar making sure belt turns freely and is not
pinched between brush bar and bottom of cleaner.
To replace the hood, align tabs (A) on hood with slots (B)
on base of cleaner. Pivot hood into position.
Secure hood into position by turning the coin slots (Fig.
6/8).
Replacing the Brush Bar
When brush bar brushes are worn, the brush bar should
be replaced.
IMPORTANT: To check condition of brushes,
disconnect cleaner from electrical outlet.
Move edge of a card across bottom plate while turning
brush bar (Fig.6/9).
To maintain cleaning effectiveness, replace brush bar if
brushes do not touch card.
Powered Hand Tool Brush Bar Replacement
When brush bar brushes are worn, the brushbar should be
replaced.
Remove tool from hose and turn it so bottom faces up.
Press the latches on both sides of tool and remove
bottom plate (A) (Fig.6/10).
Unscrew the two Phillips screws and remove belt guard
(Fig.6/11).
!
Fig.6/6
Fig.6/7
Fig.6/9
Fig.6/10
Fig.6/11
Fig.6/8
A
A
A
B
B
