1. Connect the charger plug to the
Charging Jack (8) on the back of
the sweeper (fig.4). Plug the
Charging Adaptor (12) into the
wall outlet.
2. This cordless sweeper is
powered by Ni-CAD batteries.
Before first use, they must be
charged for a minimum of 16
hours.
3. Once the batteries are fully
charged, the sweeper will run
for approximately 30 minutes
before recharging is required.
SWEEPER ASSEMBLY
1. Unpack and remove the whole
unit from packaging.
NOTE:
The charging adapter, lower
handle and edging tool are shipped
inside the dust container. Pull the
dust container straight out from the
side. (see Fig.17 Pg.7)
2. Fit the Edge Wheel (7) onto the
bottom of the Main Unit (1), (Fig.1)
NOTE:
Edge tool may already be
assembled into unit.
3. Inser t the lower handle - small
end - into the sweeper main unit.
Push until firmly in place. (Fig. 2)
1.
Before using, please ensure
that the cordless sweeper has
been initially charged for 16-
20 hours.
Your cordless sweeper will only
operate properly when the
batteries are fully charged. Your
sweeper will operate for var ying
lengths of time on a full charge.
This will depend upon the type
of sur face being cleaned.
(Longer operating time on
bare floors vs carpets.)
2. Push the On/Off switch to
operate the unit. To turn off,
press switch again.(Fig.5).
HOW TO OPERATE
YOUR CORDLESS
SWEEPER
5. Push the handle tubes and the
upper handle together. (Fig.3)
NOTE:
One metal extension tube has
a different black plastic inser t. This
tube should be inser ted into the lower
handle.
4. Place the handle into the
upward position.
Figure 3
Figure 5
on/off
switch
inser t into
lower handle
1. Remove the main
handle (fig.7).
HANDHELD
OPERATION
3. Release the Handle to an
optimum position (fig.6).
Figure 6
Figure 7
CHARGING THE
CORDLESS SWEEPER
Figure 4
4. When recharging, make sure the
unit is in the Off position.
5. To recharge, repeat step No.1
above. Charging times will var y
depending upon the amount of
usage between charging cycles.
6. The Charging Light Indicator (3)
on the top of the Main Unit (1)
will illuminate to indicate that
the sweeper is properly
charging.
NOTE: Peak performance may only be
realised after the unit has been charged
and discharged two or three times.
IMPORTANT: To maintain peak
performance of your cordless sweeper,
it is recommended that the unit be fully
discharged, then completely re-charged
at least once a month.
4
5
4. Do not use
the sweeper
‘nose down’
(fig.10).
3. Remove the brush
cover to clean
the front
sur face of
stairs* (fig.9).
Refer page 7 for details.
*With the cover removed use
only in backwards direction
Figure 9
Figure 10
2. Fold for ward
the lower
handle
(fig.8).
Figure 8
