8
maintenance/troubleshooting
Replace floating brushbar (Fig 5/4).
Replace the brush access cover by inserting the end
furthest from the brush first. Then replace the front end
before securing in place with the two screws (Fig 5/5).
6. Troubleshooting
WARNING: To reduce the risk of personal injury,
unplug the vacuum cleaner before performing
maintenance or troubleshooting checks.
PROBLEM: The cleaner won't run.
Cause:
Not properly plugged into electrical socket.
Solution:
Plug in firmly.
Cause:
No electricity in electrical socket .
Solution:
Check fuse or breaker.
Cause:
On/off button not turned on.
Solution:
Push on/off button to ‘on’.
Cause:
Blown fuse/tripped circuit.
Solution:
Reset circuit or replace fuse.
PROBLEM: Cleaner won’t pick up/loss of suction.
Cause:
Dirty water tank is full.
Solution:
Switch off and unplug cleaner. Empty dirty
water tank as shown in section 4.
Cause:
Dirty water tank not installed correctly.
Solution:
Refer to page 7 for fitting information.
Cause:
Obstruction in hose/nozzle.
Solution:
Remove hose and clear obstruction.
Cause:
Broken or worn belt.
Solution:
Replace the belt. See page 7.
Cause:
Brushbar is worn.
Solution:
Replace the brushbar. See page 7.
PROBLEM: Liquid escaping from the carpet washer.
Cause:
Dirty water tank is full.
Solution:
Switch off and unplug cleaner. Empty dirty
water tank as shown in section 4.
Cause:
Dirty water tank not installed correctly.
Solution:
Refer to page 7 for fitting information.
Cause:
Clean water tank not installed correctly.
Solution:
Make sure the tank is securely locked in place
PROBLEM: Cleaning solution won’t dispense.
Cause:
Clean water tank not installed correctly.
Solution:
Make sure the tank is securely locked in place.
Cause:
Clean water tank empty.
Solution:
Refill tank. Refer to page 6 for instructions.
!
Fig.5/4
Fig.5/5
vax.co.uk
VRS14W_User Guide_v1_V-024U User Guide 16/04/2012 16:36 Page 8
All manuals and user guides at all-guides.com
