7
operation/maintenance
Grasp the handle and hook the front of the dirty water
cleaner into the base, making sure that the front of the
dirty water tank is resting on the base.
The dirty water tank has three tabs on the underside
which MUST latch on to the underside of the base of the
cleaner. The base must be lifted so that the nozzle is
flush with the base of the cleaner.
Failure to install the dirty water tank correctly will result
in poor dirty water pick up (Fig 4/16).
While making sure the dirty water tank is resting on the
base, place the rear of the tank into the base of the
cleaner, push down on the handle until it latches.
Empty and rinse clean water tank after use (Fig 4/17).
5. Maintenance
Brush removal and replacement
NOTE: Crosshead screwdriver required
NOTE: The plug must be removed from electrical
socket before cleaning or maintaining the appliance.
Remove the water tank switch off and unplug carpet
washer.
Flip the cleaner on its side to expose the nozzle base
(Fig 5/1).
To remove the brush access cover, use a crosshead
screwdriver to remove the two screws (Fig 5/2).
Lift out the floating brushbar (Fig 5/3).
Fig.4/15
Fig.4/16
Fig.4/17
Fig.5/1
Fig.5/2
Fig.5/3
Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308
VRS14W_User Guide_v1_V-024U User Guide 16/04/2012 16:36 Page 7
All manuals and user guides at all-guides.com
