Vax VCSD-01, Руководство пользователя

Страница: 21 / 26

7
–
OPERATING INSTRUCTIONS
22
If necessary, charge the battery (see the relative
section).*
7.14 SPECIFIC INSTRUCTIONS FOR THE USE
OF MODEL VCSD-01
Connect VCSD-01 machine to a suitable 240V
power supply. It is recommended that a RCD
circuit breaker is used to provide earthed
protection.
Do not damage the feed cable; do not crush or pull
on it.
Do not run over the feed cable with the machine.
The cable could wind up in moving parts causing a
short circuit.
(
◊
) ATTENTION !!! - The VCSD-01 machine
has parts, which are connected to the
current; contact with these could cause
grave injuries or even death.
- Before executing any type of operation on the ma-
chine always disconnect it from the electrical
source.
- Never touch electric cables that are defective or
worn.
- Before gaining access to the electrical system it is
always necessary to disconnect the machine from
the electrical source.
- In the case of defective, damaged, or cracked
electric cables, replace immediately with authentic
replacement parts.
- The network of connections must be protected
from water spray.
- The patch cord for the connection of the
machine to the mains power must conforms
to current safety rules.
- The electrical system to which the machine is
connected must be equipped with a RCD cutout
switch.
- It is absolutely forbidden to use the machine in
proximity to swimming pools or stretches of water.
(
◊
) EMERGENCY SITUATIONS
In case of emergency:
- Immediately disconnect the machine from
the power mains.
- Immediately apply proper first-aid.
If an accident should occur the machine must not
be put into operation until the machine has been
sent back to Vax for inspection.