Fig.3/10
Fig.3/11
Fig.3/12
Fit the dust bag by aligning the front of the dust
bag with the inlet slots, and position the dust
bag to fill the inside of the base (Fig.3/7).
8
5
Fig.3/7
Fig.3/8
Fig.3/9
Replace the motor top, ensuring that the
dust bag is not trapped. Ensure the motor
top is secured to the base with the two clips
(Fig.3/8).
Insert the flexible hose into the inlet on the main
body of the vacuum cleaner. Push in and twist
clockwise a quarter turn until tight (Fig.3/9).
Push the extension tubes onto the end of the
handle (Fig.3/10).
Fit the combination floor tool by pushing on to
the extension tube (Fig 3/11).
On/Off Button
Fully unwind the power cord and plug the
cord into the electrical outlet. Turn the vacuum
cleaner on by depressing the button located
on the top of the carry handle (Fig.3/12). The
vacuum cleaner can be turned off by pressing
the on/off button again.
Fig.7/1
Fig.7/2
Fig.7/3
A
A
1
B
B1
7. Assembly
1. Push solution tube connector (A) firmly
into Solution Port (A1). Twist solution tube
connector (A) a quarter turn to the right to
lock into place (Fig.7/1).
4. Replace Clean Water Tank (A) inside Dirty
Water Tank (B) taking care to ensure that
the space to allow the dirty water back into
the tank is lined up with the Solution Port
(C) (Fig.6/4).
2. Push hose connector (B) firmly into Hose
Connection Port (B1). Twist to the right until
hose connector locks into place (Fig.7/2).
Fig.6/5
Fig.6/4
A
B
C
A
B
C
5. Replace Motor Container (A) ensuring that
the Solution Pump Hose (B) is aligned with
the hole in the Clean Water Tank (C) so that
it goes inside when the Motor Container is
clipped back into position (Fig.6/5).
WARNING:
Machine must not be
plugged in during this stage.
3. Push one end of the extension tube into
the handle of the hose (Fig.7/3).
