5
Vax Careline
0870 606 1248
operation / accessories
4. How to Operate
1.
Plug the cord into an electrical outlet and turn on by
pressing the on/off pedal, located on the back left of the
cleaner (1).
To unlock the handle from the upright position press the
handle release pedal (2) down.
Move the handle to the desired position (a) for storage and
position (b) for normal operation. To clean under furniture,
press the release pedal again and use position (c) (Fig.4/1).
5. Accessories
NOTE: This unit is fitted with a constantly rotating
brush bar. To avoid damage to your carpet, ensure
the unit is not left on the stair tread when using the
accessories.
1.
Make sure the vacuum cleaner has been switched off
and is in an upright position. Remove the lower hose by
twisting and pulling away from the side connector.
Remove the hose from the hose holder (Fig.5/1).
2.
For hard to reach areas when additional hose length is
required, use the extension wand. It fits over the end of
the hose handle.
Choose the accessory that suits your need or use the hose
alone.
To fit the attachments push them firmly on to the end of
the extension wand or hose handle (Fig.5/2). To remove
the tool, twist and pull apart gently.
TurboTool
(U91-P3P only)
:
Make sure the cleaner is turned
off before fastening TurboTool. Attach TurboTool to hose
end as all other accessories. For best pick up use
backward strokes on the surface being cleaned.
Fig.4/1
a
b
c
1
2
Fig.5/1
Fig.5/2
WARNING:
This cleaner has a constantly
rotating brush bar which, when left in contact
with lino, parquet and other hard flooring could
potentially cause some damage to the floor surface.
NOTE:
Vax recommends that you raise the height of
the brush bar when using this cleaner on lino and hard
flooring. Vax cannot be held responsible for damage to
these surfaces if the customer fails to take notice of
this recommendation.
!
Vax U91-P3 User Guide.qxd:U91-P3 User Guide 15/12/08 09:34 Page 5
