Insert brushbar through belt an position belt in groove (A)
on brushbar (Fig.6/18).
Brushbar
IMPORTANT: Disconnect cleaner from electrical
outlet.
WARNING: Brushbar can start suddenly. Unplug
cleaner before turning it over.
Replacing Brushbar
When agitator brushes are worn, the brushbar should be
replaced.
Inspecting Brushbar
To check condition of brushes, move edge of a card
across bottom plate while turning brushbar.
To maintain cleaning effectiveness, replace brushbar if
brushes do not touch card (Fig.6/18).
11
Vax Careline
0844 412 8455
maintenance
Reposition bottom plate and 6 Phillips head screws.
Tighten screws securely (Fig.6/16).
Inspecting V-Belt
The V-belt is designed to last for a long time and is not
normally replaced. However, if the V-belt is cracked, gouged
or broken, it should be replaced.
Slide flat belt off large pulley as shown in Fig.6/14.
To remove V-belt, slide back of belt over pulley (A). Then
firmly pull on belt and ‘snap’ it out. Discard used belt.
To install new belt (with lettering on outside of belt), slide
back of belt over pulley and pull front of belt toward groove
(B) next to pulley. Belt will ‘pop’ into place (Fig.6/17).
Fig.6/16
Fig.6/18
Fig.6/17
A
A
A
B
B
Fig.6/15
!
!
Fig.6/18
U90-M7 Series User Guide.qxd:UG
16/9/09
15:37 Page 11
