Using your machine
Using your machine
Place the microfibre pad
on the floor with the tab side
facing up. Place steamer onto the
pad making sure the entire pad
covers the floorhead.
Press the handheld release
button and gently pull the
handheld from the main body.
Place your foot on floorhead and
pull handle backwards to recline.
Attach the chosen tool to the 360⁰
connector before attaching both the
connector and tool to the handheld.
To release the carpet glider, place
your foot on clip and push down.
Lift steamer to remove.
Plug into mains. The blue light
will illuminate to indicate power
on. The green light will illuminate
to indicate the steamer is
ready to use.
To produce steam squeeze
the trigger in short bursts.
Don’t hold the trigger continuously
to prevent over wetting carpet.
Line up the edge of tool with the
360⁰ connector. In a hinge like
manner, push tool on to 360⁰
connector until it clicks
securely into place.
To produce steam squeeze
the trigger.
Move the steamer slowly backwards
and forwards across the carpet
paying particular attention to high
traffic areas. Squeeze/release
trigger as required.
Push the 360⁰ connector with tool
attached into the handheld nozzle
until it clicks into place. Make sure
the locking clip is securely attached
by gently pulling the 360⁰ connector.
With microfibre pad attached,
push the floorhead into front
of the carpet glider, then place
back of the floorhead into the clip.
The carpet glider should only
be used when refreshing carpets.
Before use, remove tank, fill
with water and replace tank
to handheld unit.
Refreshing carpets
Using the handheld steamer
IMPORTANT:
When using on carpets, always make sure the microfibre cleaning pad is used and covers the floorhead entirely
before using the carpet glider. Only use the carpet glider when refreshing carpets.
WARNING:
Always unplug the handheld before attaching/detaching the 360⁰ connector and tool to the handheld. The steamer and
accessories get very hot during use, always allow them to cool down before handling.
IMPORTANT:
Always check the tools are clean and free from debris, don’t use if damaged, broken or worn.
Plug into mains. The blue light will
illuminate to indicate power on.
The green light will illuminate to
indicate the steamer is ready to use.
Choose a tool.
TIP
If the area you
are cleaning is
becoming too wet,
squeeze the trigger
in short bursts.
Содержание S84-P1-B
Страница 1: ...S84 P1 B LET S GET STARTED CHANGE THE WAY YOU STEAM CLEAN...
Страница 12: ...Notes Notes...