![background image](http://html1.mh-extra.com/html/vax/rapide-xl-ultra-v-027x/rapide-xl-ultra-v-027x_instruction-manual_4190783014.webp)
Troubleshooting
Problem
Cleaner won’t run
Vacuum won’t pick up/loss of
suction
Water escaping from the
Vacuum
Cleaner attachments won’t
spray
Cleaner won’t dispense solution
No soap dispensing
Will not dispense water
Possible Cause
• Power cord not firmly pushed into
a mains socket.
• Blown fuse or tripped circuit breaker.
• Nozzle hose attachment cover not
closed.
• Dirty water tank is not installed
correctly.
• Nozzle not installed correctly.
• Floor/Tool selector in wrong position.
• Dirty water tank is full.
• Brushbar worn.
• Broken or worn belt.
• Nozzle/Dirt passage clogged.
• Clogged hose inlet.
• Dirty water tank is full.
• Dirty water tank not installed correctly
• Hose not installed correctly.
• Solution tank not installed correctly.
• Water supply hose not connected
properly
• Solution tank not installed correctly
• Pick up tube blocked.
• No soap.
• Soap switch off.
• Soap tank empty with soap power ON
Possible solution
• Plug cord in firmly.
• Check fuse/breaker. Replace fuse or
reset breaker.
• Close the hose attachment cover.
• See ‘Emptying the dirty water tank’
• See ‘Emptying the dirty water tank’.
• Move selector to the correct position.
• Empty dirty water tank.
• Replace the brushbar.
• Replace the belt.
• Remove hose, remove obstruction.
• Remove hose, clean inlet.
• See ‘How to operate your cleaner’.
• See ‘Emptying the dirty water tank’.
• See ‘Emptying the dirty water tank’
• See ‘Hose attachments’.
• See ‘How to operate your cleaner’.
• See ‘Hose attachments’.
• See ‘How to operate your cleaner’.
• Clean pick up tube by soaking in water
• Fill soap tank with Vax AAA Carpet Cleaner.
• Turn soap switch on.
• Fill soap tank or shut soap power OFF.
2
3
4
Tilt cleaner off the carpet. Grasp
the brush bar and pull the right side
of its chamber.
Tilt the brushbar down to the
ground and remove the silver cap.
Slide the worn brushbar out of the
cleaner.
To install a new brushbar. Feed the
brushbar through the opening until
the screw plate and screw hole are
lined up (as above).
Note:
The black cap behind the
silver screw plate will be through the
hole.
Replace the silver cap to right side
of the brushbar. Lift the brushbar up
and align with the brushbar
chamber. Push the screw plate
towards the screw hole until the
flush and replace the screw.
25
26
V-027X User Guide 7/9/06 15:04 Page 13