Safety Information
3
2. Safety Information
FOR HOUSEHOLD USE ONLY.
When using the carpet washer, basic safety
precautions should always be observed, including the
following:
1.
Only use the vacuum cleaner indoors on dry
surfaces.
2.
Turn off the carpet washer controls before
connecting to or disconnecting from the mains
supply.
3.
Always unplug the carpet washer before
connecting or disconnecting the vacuum hose.
4.
Close attention is necessary when used by
or near children. Do not allow children to use
as a toy.
5.
Use only as described in this manual. Use only
the manufacturer’s recommended attachments.
6.
Do not use the carpet washer if it has been
dropped, damaged, left outdoors or dropped into
water. Do not use the carpet washer with a
damaged cord or plug. If the supply cord or plug
7.
Do not pull or carry by the cord. Do not use the
cord as a handle, close a door on the cord or pull
the cord around sharp edges or corners. Do not
run the carpet washer over the cord. Keep the
cord away from heated surfaces.
8.
Do not handle the plug or vacuum cleaner with
wet hands. Do not use outdoors or on wet
surfaces.
9.
Do not put any objects into openings. Do not use
with any openings blocked and do not restrict air
flow. Keep all openings free of dust, lint, hair or
anything that may reduce airflow.
10. Keep hair, loose clothing, fingers and all parts
of the body away from openings and moving parts.
11. Do not pick up hot coals, cigarette butts,
matches or any hot, smoking or burning objects.
12. Do not pick up flammable or combustible
materials (lighter fluid, petrol, kerosene, etc)
or use in the presence of explosive liquids
or vapours.
13. Do not vacuum up harmful or toxic material
(chlorine bleach, ammonia, drain cleaner, etc).
14. Do not vacuum up hard or sharp objects such
as glass, nails, screws, coins, etc.
15. Do not use without the filters in place.
16. Take extra care when vacuuming on stairs.
17. Keep vacuuming area well lit.
18. Store the carpet washer indoors in a cool,
dry area.
19. Turn off the switch before unplugging.
20. Use only CE-approved 13 amp extension cords.
Non-approved extension cords may overheat.
Care should be taken to arrange the cord so that
the cord cannot be pulled or tripped over.
WARNING
:
Always switch off and unplug the carpet
washer from the electrical outlet before assembling,
opening or emptying the water tanks, or before
connecting/disconnecting the attachments.
CAUTION
:
The carpet washer is a very powerful unit.
Before plugging the cord into the outlet make sure the
switch is in the ‘off’ position. Hold the carpet washer
firmly when starting and in use.
IMPORTANT:
If the inlet is blocked, switch off the
carpet washer and remove the blockage(s) before re-
starting the carpet washer.
IMPORTANT:
Washing filters improves vacuum
performance. Make sure all filters are completely dry
before inserting back into the carpet washer.
This carpet washer is intended for household use only
and not for commercial or industrial use.
PLEASE KEEP THESE INSTRUCTIONS FOR
FURTHER USE.
Motor Thermostat
IMPORTANT:
The motor is equipped with a thermal
cut-out. If for any reason, the carpet washer should
over-heat, the thermostat will automatically turn the
unit off. Should this occur, unplug the carpet washer
from the electrical outlet and turn off the switch.
Remove the dirty water tank and empty. Clean the
filters. Allow the cleaner to cool for approximately
one (1) hour. To re-start, plug into an electrical outlet
and switch back on.
Vax V-022(Q).qxd 23/8/06 11:47 Page 3
