18
7
8
Belt or Brush removal and replacement
When replacing the belt, first slide it
onto the motor shaft. Then slip the
brush bar through the belt. Place
the belt in the area of the brush
without bristles.
Slide the brush bar into the nozzle,
ensuring that the brush bar end
caps are orientated correctly, see
inset picture.
Manually turn the brush bar to
check that it is fitted properly.
Replace the belt cover by inserting
the end furthest from the brush first.
Then replace the front of the belt
cover before securing in place with
the two screws.
Phillips screwdriver required
Troubleshooting
Problem
Cleaner won’t run
Vacuum won’t pick up/
loss of suction
Dust escaping from the
vacuum
Cleaner won’t dispense
solution
Possible Cause
• Power cord not firmly pushed into
a mains socket.
• Blown fuse or tripped circuit breaker.
• Dirty water tank is not installed
correctly.
• Dirty water tank is full.
• Broken or worn belt.
• Brush bar is worn.
• Nozzle/dirt passage is clogged.
• Dirty water tank is full.
• Dirty water tank is not installed
properly.
• Solution reservoir not installed
correctly.
• Solution reservoir not installed
correctly.
• Solution tank empty.
Possible solution
• Plug cord in firmly.
• Check fuse/breaker. Replace fuse or
reset breaker.
• Refer to page 15 for fitting information.
• See ‘Emptying the dirty water tank’.
• Replace the belt.
• Replace the brush bar.
• Remove obstruction.
• Empty dirty water tank.
• See ‘Emptying the dirty water tank’
• See ‘How to operate your cleaner’.
• See ‘How to operate your cleaner’.
• Fill tank see page 8 and 9.
19
