10
11
7
8
9
How to operate your cleaner
Plug the cord into a mains
electricity socket. Turn the power
and brush bar switches on.
The switches are located on the
front of the cleaner, above the
solution reservoir.
The power switch controls the
vacuum motor and pump, the brush
switch only turns the rotating brush
bar on and off when the power
switch is on.
Press on the handle release pedal
and pull the cleaner back into a
reclined position.
While pressing the solution release
trigger, pull the cleaner in a
backward motion. Release the
trigger and push forward in the
same path to remove the dirty
water and solution from the carpet.
Repeat if necessary, when the dirty
water reaches the max fill line on
the dirty water tank, empty the tank.
1
2
3
Hose Attachments
Put cleaner in its upright
position. Remove tools
from storage caddy.
Assemble as shown.
Connect the upholstery
attachment to the trigger
adapter.
REMOVE THE TANK DOOR
from the top of the dirty
water tank.
Insert the hose adapter
into the top of the dirty
water tank.
4
Connect the hose water
supply plug into the
socket on the lower left side
of the cleaner.
NOTE: DO NOT OVERSATURATE THE UPHOLSTERY
IMPORTANT: FOR BEST CLEANING RESULTS USE STEADY, MODERATE, FORWARD AND BACKWARD MOTION.
Make sure upholstery is dry before use.
NOTE: If the hose attachment door is not replaced, there will be no suction through the nozzle and the unit will not operate properly.
Important: Never leave the cleaner unattended with the power on.
Vacuum carpets thoroughly with dry vacuum cleaner before washing
.
