vax.co.uk
5
How To Use
Before you begin cleaning
Pour required dose of solution
(approx. 40ml per 1.0L of water.)
Remove clean water tank.
Mix the solution with warm
water (max 40 C) and fill
tank with solution.
Operating your carpet washer
Your dirty water tank is fitted with a float. When the dirty water tank is full or the floor head is not in contact with the carpet
the float will shut off the suction at the floor nozzle. You will be able to hear if this has happened as the motor noise on the unit
will increase. Once the float is activated, empty the dirty water tank if full. If the dirty water tank is not full then turn off your
machine at the power switch and wait for the float to settle before re-starting.
Place the bottom of the
solution reservoir into the
cleaner and push into place.
O
Do not saturate your carpet.
• Test for colourfastness – Wet a white absorbent cloth with the solution. In a small, hidden area of your carpet, gently rub the
surface with the dampened cloth. Wait ten minutes and check for colour removal or bleed with white paper towel or cloth. If your
carpet has more than one colour, check all colours.
• When cleaning an entire room, move furniture out of the area to be cleaned. If the furniture is too heavy to move, place aluminium
foil or wax paper under legs. This will prevent wood finishes from staining your carpet. Pin up furniture skirts and curtains.
IMPORTANT:
Carpets should be dry vacuumed thoroughly before washing.
IMPORTANT:
Only use Vax carpet cleaning solution. Using other solutions may cause excess foaming. Excessive foam will prevent
the machine from working effectively. Using other solutions will invalidate the guarantee.
