![background image](http://html1.mh-extra.com/html/vax/rapid-power-series/rapid-power-series_manual_4191652008.webp)
8
Using the carpet washer and cleaning modes
CAUTION:
Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
IMPORTANT:
Your dirty water tank is fitted with a float. When the dirty water tank is full, or the floorhead is not in contact
with the carpet, the float will shut off the suction on the carpet washer. You will be able to hear if this has happened as the
motor noise on the machine will increase. Once the float is activated, empty the dirty water tank if full. If the dirty water tank
is not full then turn off your machine at the power switch and wait for the float to settle.
NOTE:
Carpets should be dry vacuumed thoroughly before washing. For best overall results use in deep clean mode.
For heavily soiled areas it may be necessary to repeat the cleaning process. Make crisscrossing strokes to the original
pattern and overlap each pass.
Quick Clean Mode:
Best for a quick, surface clean because carpets dry in as little as 1 hour.
Deep Clean Mode:
Best overall results for a thorough, deep clean.
Press the clean water/
solution tank release
button, pull and lift to
remove the tank.
Fill the clean water tank
with warm water (max
40°C). Replace the cap
before refitting the tank.
Tilt the clean water/
solution tank and line up
onto the carpet washer.
Push the tank back until
it clicks into place.
Twist the water tank cap
anti-clockwise to remove.
Pour VAX carpet cleaning
solution into the tank.
Replace the cap.
Choose the cleaning mode
by turning the dial on the
base.
Quick Clean Mode
: Best
for a quick, surface clean
with carpets drying in as
little as 1 hour.
Deep Clean Mode
: Best
overall results for a
thorough, deep clean.
Turn the wash/rinse dial
to ‘wash’. The SpinScrub
brushes deep clean your
carpets with water and
detergent removing dirt
and stains.
Twist the solution tank
cap anti-clockwise to
remove.
TIP
Always empty and rinse out the clean and
dirty water tanks and leave to air dry before
replacing. Do not leave solution stored in
the tanks between uses.
Using your machine