14
Press the dirty water tank
release latch and pull the
tank to remove.
Pull and lift the dirty water
tank clip to release the lid.
Lift the tank lid to remove.
Emptying and cleaning the dirty water tank
Clean the filter screen
located at the back of the
dirty water tank.
Empty the dirty water over
the sink or toilet. Rinse the
dirty water tank and lid
under water (max 40°C)
to remove dirt/debris.
MAINTENANCE & CLEANING
CAUTION:
Always switch off and unplug the machine before performing any maintenance/troubleshooting checks.
The dirty water tank is fitted with a float. When the dirty water tank is full or the floorhead is not in contact with the carpet,
the float will activate by shutting off the suction on the machine. This will be noticeable as the motor noise on the machine
will increase. If the float has been activated empty the dirty water tank if it is full. If the dirty water tank is not full turn off the
machine at the power switch and wait for the float to settle before restarting your machine.
Empty and rinse out the clean and dirty water tanks and leave to air dry before replacing.
Do not leave solution stored in the tanks between uses.
To refit the dirty water tank,
tilt and line up the front
of the tank onto machine.
Push back until it clicks
into place.
Hook the dirty water tank clip
onto the lid and push down
to lock into place.
To replace the lid, hook the
tab on the front of the lid
into the front of the dirty
water tank.
