15
maintenance
Replace and tighten screws.
To replace bottom plate, insert the four tabs on edge of
bottom plate into slots on front of tool.
Pivot bottom plate down and snap closed (Fig.6/18).
TurboTool Belt Replacement
The TurboTool belt is designed to last a long time and is
not normally replaced. However, if the belt is cracked,
gouged or broken, it should be replaced.
Remove tool from hose. The belt can be seen through the
top of the nozzle or by removing the bottom plate and
belt guard (Fig.6/19).
Remove tool from hose. Remove bottom plate, belt guard
and brushbar as described previously.
Grasp turbine (A) and pull firmly to remove. Remove belt
from turbine pulley (B). Replace with new belt (Fig.6/20).
With flat sides of turbine retainers (A) pointing down, slide
retainers into grooves (B) in tool housing and snap into
place (Fig.6/21).
Replace brushbar, belt guard, and bottom plate as
described previously.
Fig.6/17
Fig.6/18
Fig.6/20
Fig.6/21
Fig.6/19
A
A
A
B
B
Vax Careline
0844 412 8455
U90-M5 & U90-M6 Series User Guide.qxd:VZL-6015 & 6016 9/9/09 16:45 Page 15
