![background image](http://html.mh-extra.com/html/vax/mach-7-vzl-6017-series/mach-7-vzl-6017-series_manual_856807006.webp)
6
how to operate / accessories
Brushbar height adjust
The cleaning of carpet and rugs takes place at the nozzle
(A). When it is necessary to raise and lower the nozzle for
various carpet pile heights, turn the brushbar height
adjuster knob (B) to the desired setting (Fig.4/6).
Settings
For maximum cleaning performance, the following carpet
height settings are recommended (Fig.4/7):
• Lowest setting for all types of carpet.
• Higher settings: for very deep pile carpet, where easier
pushing effort is desired, while maintaining good
cleaning performance.
NOTE: If the cleaner is difficult to push, turn knob to
the next higher setting.
WARNING:
The brushbar must NOT be rotating
when cleaning hard floors. Switch the brushbar
off to prevent damage to lino, parquet and other hard
flooring.
Brushbar on/off
The brushbar shuts off automatically for tool use, when
the cleaner is in the upright position. To manually shut
off the brushbar for cleaning hard floors, step on the
pedal (A). The indicator (B) will show red in the “brushbar
off” window. To turn the brushbar on, step on the pedal
again. The indicator will show red in the “brushbar on”
window. (Fig.4/8)
5. Accessories
Select correct tool
(Fig.5/1)
A. Dusting brush/upholstery tool:
use with brush for
carved furniture, table tops, books, lamps, lighting
fixtures, venetian blinds, skirting boards and shutters.
Remove brush to clean upholstered furniture, draperies,
mattresses, clothing, and carpeted stairs.
B. TurboTool:
may be used for upholstered furniture,
mattresses, clothing, automobile interiors and carpeted stairs.
C. Crevice tool:
may be used in tight spaces, corners and
along edges in such places as upholstered furniture,
stairs and skirting boards.
D. Extension tubes:
are used to give extra length to
your hose. Use them with any of the above tools.
E. Hard floor tool:
(available on some models only) use
on hard surface floors.
Attach extension tube and tools
Attach extension tube or tool to the hose (A).
Attach tool to extension tube (B) by pushing it firmly
onto the wand.
Twist extension tube or tool slightly to tighten or loosen
the connection (Fig.5/2).
Fig.4/8
Fig.5/1
Fig.5/2
A
A
C
D
E
B
B
Fig.4/6
Fig.4/7
A
A
B
B
HIGH
LOW
!
vax.co.uk
VZL-6017 User Guide v3.2_Vax VZL-6017 09/01/2012 17:25 Page 6