![background image](http://html.mh-extra.com/html/vax/impact-702-u86-ib-re/impact-702-u86-ib-re_lets-get-started_856786004.webp)
Insert the back panel
into the loorhead.
Insert the lower cord
hook into the hole
at the bottom of the
back panel.
Now take the small
clip and push it down
between the end of the
cord hook and the
machine, to lock the
cord holder in place.
Place the dirt container onto the machine.
Ensure the dirt container tabs line up with
the holes in the post motor ilter cover.
Assembling your upright
Ensure that the back of
the dirt container connects
to the inlet tube.
Place dirt container on
machine and click into
place at the back panel.
Insert the short end of the
hose into the tube at the
back of the machine and
turn to lock.
Push the hose end into the
hose to machine connector.
Before you begin cleaning
• Always switch of and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments,
or removing and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the
thermostat will automatically turn the vacuum cleaner of. If this happens, switch the vacuum cleaner of and unplug
from electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the
vacuum cleaner to cool for approximately 1 hour (if you have cleaned the ilters please wait 24 hours for the ilters
to fully dry before putting back into the vacuum machine).
• Filters require cleaning at least every 3 months.
• If the vacuum cleaner is blocked, switch of and unplug before removing the blockage.
Push the on/of switch to
turn machine on.
Place your foot gently on the loorhead and pull the
handle backwards to recline the machine.
Getting started
Using your machine
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Push the hose end into the hose to machine connector.
Attach TurboTool clip to the
handle. Snap TurboTool
into position.*
Inset the handle into the
top of the back panel until
it clicks into place.
Remove hose end from
the loorhead.
Attach accessory
adapter to hose end.
If required use tool
connector.
Push the quick release
cord hook to one side to
release the power cord.
Turn the height adjuster
dial backwards for the
carpet setting.
Turn the height adjuster dial
forwards for the hard loor setting,
the loorhead will tilt forward.
*Not applicable for all models
Using accessories
Choose an accessory.