Accessories
Let’s talk technical
Clearing a blockage from the brushbar
Replacing brushbar
Using a dry cloth or soft
dusting brush remove any
dust/debris from
terminals on battery
charger, battery and
vacuum cleaner.
Remove battery and lie
the vacuum cleaner flat,
exposing the brushbar.
Push the plate locks
towards each other.
Remove battery and lie
the vacuum cleaner flat,
exposing the brushbar.
Push the plate locks towards
each other. Squeeze the
clips on the brushbar cover
towards the brushbar and lift
off brushbar cover.
Squeeze the clips on the
brushbar cover towards
the brushbar and lift
off brushbar cover.
Remove brushbar firstly
lifting the side of brushbar
not connected to belt.
Unloop the belt from
the brushbar and lift
to remove.
Using a pair of scissors cut any hair
or debris from around the brushbar.
Refit brushbar cover clicking clips
into place and pushing plate locks
apart to secure.
Refit replacement brushbar,
looping the belt around the brush
bar first. Align both sides of the
brush bar and push into base.
Refit brushbar cover clicking clips
into place and pushing plate locks
apart to secure.
Cleaning terminals
CAUTION:
If the brushbar has been obstructed, the Motor Protection Sensor may have been activated.
Remove the battery and dirt container and clear any obstruction from the brushbar.
Wait 30 minutes for the vacuum cleaner to reset itself.
Replace the battery and dirt container. Roll the On/Off brushbar control forward to carpet mode.