Using your machine
Using your vacuum cleaner
Press the On/Off button to switch
‘On’ the vacuum. The LED Indicator
will illuminate a blue light indicating
that the power is on. Press the
On/Off button again to switch the
vacuum ‘Off’.
Using the accessories
Choose an accessory and install the chosen
accessory into the vacuum by inserting the
accessory into the dust inlet.
IMPORTANT:
During operation, move the vacuum back and forth over a surface. Use even strokes and allow the
vacuum to pick up the debris. For best performance, it is advisable to empty the dust container after each use.
CAUTION
: Always switch off the vacuum cleaner before connecting or disconnecting the accessories or
removing and emptying the dust container.
CAUTION:
Always take extra care when using the vacuum cleaner on the stairs. Ensure that the vacuum is switched
off before fitting or removing accessories.
NOTE:
The crevice tool can be used to clean in hard-to-reach
places. The brush tool can be used for general cleaning, such
as: benchtops, car seats, and floor surfaces. The brush tool
can be installed onto the end of the crevice tool for additional
reach, if required.
To empty the dust container, while
holding the vacuum, press the dust
container release button to release
the dust container from the vacuum.
Empty the dust container over a bin
then reinstall the dust container,
ensuring that it clicks into place.
To reinstall the dust container, at an
angle, hook in the bottom of the dust
container, as shown. Hinge the dust
container towards the vacuum until
it clicks back into place.
