7
Vax Careline
0870 606 1248
usage / maintenance
Dry or loose debris will also collect on the filter screen in
the tank lid (Fig.4/5).
Remove debris from screen. The filter screen may also be
cleaned by rinsing it under running water.
The tank lid contains a washable, reusable filter. Clean this
filter when suction is low or reduced.
To replace lid, align tab on lid with hole on front of tank.
Snap latch over tabs on back of tank (Fig.4/6).
To replace tank, insert bottom of tank into cleaner and
pivot top portion until it is locked in place.
5. Maintenance
Battery Charging
The battery indicator has three colours.
• The indicator will be
SOLID ORANGE
when the unit is
plugged into the charger and there is no charge left on
the battery.
• The indicator light will be
SOLID GREEN
when the
battery is at full charge, and the cleaner is plugged into
the charger. During cleaner use, when the battery is low
and there is approximately two minutes of run time left,
the indicator light will flash.
• The indicator light will
BLINK RED
if the battery is low
and the cleaner is not plugged into the charger.
The cleaner can be on a constant charge so it is always
ready for use. However, if the cleaner will not be used for
several weeks at a time, unplugging it is recommended.
Refer to Section 3 for battery charging instructions.
Cleaning the Filter
Turn cleaner off.
Remove dirty water tank and lid (as Fig.4/3 - 4/4). Remove
filter lid, then remove filter (Fig.5/1).
Remove loose debris from filter by either brushing or
tapping the filter. The filter may also be rinsed (max water
temperature 40°C) for additional clearing. Allow filter to air
dry between uses.
Replace filter lid. Press down firmly to secure the seal.
Cleaning the Nozzle
Turn cleaner OFF.
The cleaner’s nozzle can be removed for easy cleaning.
Slide the two nozzle release latches outward (Fig.5/2).
Fig.5/1
Fig.4/6
Fig.4/5
Vax V-122 User Guide.qxd 29/6/07 13:49 Page 7
