www.vax.co.uk
6
preparing the cleaner
To remove hose: Squeeze the two locking latches on top
and bottom of hose. Remove hose from port. Close hose
inlet securely (Fig.3/12).
Select Tool
Powered SpinScrub Hand Tool
Has rotating brushes (Fig.3/13(A)).
Use on carpet to clean spots, small areas or stairs.
Stair/Upholstery Nozzle
Has built-in brush (Fig.3/13(B)).
Use on small areas of carpet, stairs and upholstery to
agitate embedded dirt and stains.
Attach Tool
Slide tool onto hose. Snap tool over tab on hose.
To remove tool: Push forward and up on latch and slide tool
off hose.
Drain the hose
NOTE: The handle must be in the upright position in
order to get cleaning solution through the hose.
When finished using the hose and tool, remove water from
the hose.
Turn deep cleaner on and hold end of hose up for several
seconds.
Do not press trigger
.
Turn deep cleaner off and unplug it.
Hold hose connector in sink and press trigger to remove
solution from hose (Fig.3/14).
Store Hose
Unplug cleaner from electrical outlet.
Hook hose connector into caddyand wrap hose around
caddy in a anticlockwise direction (Fig.3/15).
Hook tool connector, ‘SpinScrub’ tool and upholstery tool
into caddy.
Hose Caddy
You can either store the hose caddy on the cleaner or
remove it to store separately.
To store caddy on the cleaner, slide tabs on caddy into
slots on back of cleaner. Hook top of caddy to cleaner.
Wrap cable around cable hooks on caddy. Rotate top hook
to release cable.
Fig.3/14
Fig.3/15
Fig.3/11
Fig.3/12
Fig.3/13
A
A
B
B
Vax V-123 User Guide.qxd 10/8/07 15:43 Page 6
