Before you begin cleaning
• Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments,
or removing and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the
thermostat will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug
from electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the
vacuum cleaner to cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters
to fully dry before putting back into the vacuum machine).
• Filters require cleaning at least every 3 months.
• If the vacuum cleaner is blocked, switch off and unplug before removing the blockage.
Push the on/off switch to
turn machine on.
Place your foot gently on the floorhead and pull the
handle backwards to recline the machine.
Taking care of your machine
Remove hose end from
the floorhead.
Attach accessory
adapter to hose end.
If required use tool
connector.
Push the quick release
cord hook to one side to
release the power cord.
Turn the height adjuster
dial backwards for the
carpet setting.
Turn the height adjuster dial
forwards for the hard floor setting,
the floorhead will tilt forward.
Using accessories
Choose an accessory.
Using your machine
MAX
40˚C
TA
P
24hr
Cleaning the pre-motor filter
Press dirt container release
button to remove the dirt
container.
Place fingers under the
catch of the dirt container
lid and pull to release it.
The lid will lift on a hinge.
Use the tab on the filter to
pull the filter out of
it’s housing.
Tap the filter over a bin
to release dirt.
Hold the dirt container over a bin
and unclip the lock on the bottom
of the dirt container, allowing the
dirt to fall out.
Close the base of the dirt
container and click the dirt
container back on to the
back panel.
Emptying and cleaning the dirt container
MAX
40˚C
TA
P
24hr
MAX
40˚C
TA
P
24hr
Wash the filter under running
water (40 degree max).
Leave to fully dry for a least
24 hours before placing back
in the machine.
U86-AB_e_Series_Action_802_UG_[J2543]_Amd_02.07.14.indd 8-9
02/07/2014 13:47