Vehicle care
177
2. Carefully pull lamp assembly from
retaining pins on the outer side
and remove.
3. Detach wiring connector from
lamp assembly.
4. Rotate bulb holder anticlockwise
to separate from lamp.
5. Renew bulb.
6. Push to install the bulb holder into
the lamp, then rotate clockwise to
secure.
7. Reattach wiring connector to lamp
assembly and check that it is
located correctly.
8. Replace lamp assembly into
original position, ensuring that it is
seated correctly on retaining pins.
9. Replace the three bolts.
Side turn lights
1. Release lamp assembly from
wing by depressing clips using a
suitable tool and lift out lamp
assembly from aperture.
2. Remove bulb holder from lamp
assembly by rotating
anticlockwise and renew bulb.
3. Install bulb holder in lamp
assembly and install lamp
assembly into aperture.
Centre high-mounted brake
light
Rear doors
1. Open the rear doors.
2. Remove the two bolts from inside
the rear doors.
Содержание VIVARO
