FILLING WITH WATER
Ensure the iron is disconnected from the power supply.
Turn the steam control knob to position“
”
Fill with water through water filling inlet.(Do not exceed main level mark on the water
tank.)
SETTING THE TEMPERATURE
**
Synthetics-silk
**
Wool
***
Cotton~linen
- Stand the iron upright
-
Set temperature control to ironing temperature.
-
Insert the mains plug into the main supply.
-
After the indicator light has gone out and comes on again, you may start ironing.
Will go out from time to time during ironing.
STEAM-IRONING
●Set th
e temperature control to position
**
for moderate steam and to
***
for maximum
steam. with conventional steam irons, water may leak from the sole plate if a too low
temperature has been selected.
●Ensure that there is enough water in the water reservoir.
﹣
Stand the iron on its heel
﹣
Insert the mains plug into the wall socket.
﹣
Wait a little while for the indicator light to go out and come on again.
﹣
See the variable steam knob to adjust the steam.
BURST OF STEAM
●By
pressing button an intense
“Burst”
of steam is emitted
from the soleplate.
●To prevent water leaking from the sole plate,
do not keep the steam control
button depressed for more than 5 seconds.
SPRAY SETTING
●At any temperature by pressing the spray button a couple of time the
laundry can be
damped down.
●Ensure that there is enough water in the water reservoir.
DRY IRONING
●Turn
the
steam knob to the position “
”(=no steam).
STORAGE
●Remove the mains plug from the wall socket.
●Pour any remaining water out of the water reservoir.
●Set the steam knob to no steam position.
●Stand the iron upright and let it cool down sufficiently.
SELF CLEAN
The function of self clean is to clean the soleplate after using the iron for approximately 6
months.
●Fill the iron and plug in
●when the temperature attaches MAX,
press and turn the adjustable steam button
direction from mark “
” to “
” ,then pull
out the self clean-button for about 1 minute,
