16MOUNTING SWITCHES
Activating and deactivating additional optional RH RF switch (11VE20014):
Sign up:
Unplug the ventilation unit and plug it back in. After this, the ventilation unit will
search for new switches for 10 minutes. Then take out the batteries and replace
them (see RH RF switch battery replacement).
Touch the bottom right operating zone for at least 3 seconds.
When all LEDs
are flashing, release the operating zone. If the
pairing is successful the LED
in the upper left corner will light up green twice and
a LED will light up on
the right indicating the respective position of the
RH RF switch is located.
Tip: You can connect one switch to a maximum of 3 units:
Momentarily de-energise the switch by removing the batteries from the sensor
and inserting them again (see RH RF switch battery replacement). The switch
can disconnect ventilation units for 10 minutes. Touch the lower right control
area for at least 10 seconds. When all the
LEDs light up for the second time,
release the control zone.
In case of several registered ventilation units, all
registered units are now logged off. The LED of the switch lights up red four
times to indicate that the units have been disconnected.
