1.Configure a workstation with the following settings:
Network IP address 192.168.0.2
Subnet Mask
255.255.255.0
2.Once the TCP/IP settings (listed above) are active on a workstation, use a DOS window or terminal session for
the following test:
...> ping 192.168.0.1
Image 3: Test TCP/IP Settings
If a reply is received as shown in the image above, everything is OK.
If a reply is not received, indicated by the messages
time out
or
destination host unreachable
:
n
Check that the workstation’s TCP/IP settings are correct (see points 1 and 2 above).
n
Check that the network cable is in good working order and correctly plugged into one of the LAN Ethernet
interfaces and your network hub or switch.
Tip
An alternative method for modifying the IDENTIKEY Appliance IP address without needing to modify your work-
station IP settings is possible with the Rescue Tool.
4. Connecting IDENTIKEY Appliance to your Network
IDENTIKEY Appliance 3.11.12 - Installation and Maintenance Guide
15
