VarTech Systems VT121 CrystalVueSeries, Руководство пользователя

Страница: 14 / 22

14
Do not use paper products as they may scratch the surface. To minimize the risk of abrasion, allow
the screen to stand dry. Special care should be taken when cleaning a touch screen or
polycarbonate shield that is installed over the screen. Abrasive and certain chemical cleaners can
easily damage the surface. Never use alcoholic or ammoniac cleaners to clean the polycarbonate
shield or a touch screen.
Note:
For best results cleaning a monitor with the optional antireflective tempered glass display shield, a
solution of denatured alcohol is recommended to thoroughly clean the display.
Replacing a Line Cord
To avoid shock and fire hazards, the monitor’s power cord should be replaced if the insulation
becomes broken or if it develops a loose internal connection.
Other Maintenance
Qualified service personnel should perform all maintenance, except for the power cord replacement
described above.
SECTION 7
7.1
Panel Mount Procedure
1. Cut and drill the panel (refer to panel mount drawing). Measurements are in inches.
Panel Mounting Cutout
2. If access to the side of the monitor is not available following installation, attach the power and video cables
to the side of the monitor at this time.
3. Install the monitor in the prepared cutout.
4. Install the lock nuts and washers, supplied with the monitor, behind the holes running along the sides and
Mechanical Drawings
Model Description Page(s)
VT121P-2 12.1" DiamondVue/CrystalVue Panel Mount Drawing (Nema 4/4x) 21
VT121C-2 12.1" DiamondVue/CrystalVue Open Frame Drawing 22