15
Scoreboard Front
ANGLE TO BE
WELDED OR BOLTED
ONTO I-BEAM
1 1/2 X 1 1/2
MOUNTING ANGLE
3/8-16 X 3/4” BOLT
3/9” FLAT WASHER
3/8-16 HEX NUT
TEK SCREW
MOUNTING BRACKET
(MOUNTED UNDER
SPONSOR PANEL RIM)
BRACKET TO BE WELDED OR
BOLTED TO ANGLE
31”
1 /
Attach the
20
’ mounting
angles to the scoreboards’
poles/I-beams with the
bottom of the angle 31” above
the top of the scoreboard for
a top mounted installation.
Attach them 31” below the
bottom of the scoreboard for
a bottom-mounted installa-
tion as illustrated. The angles
should should be flush with
the left and right ends of the
2
0
’ long scoreboard. Welding
is recommended.
If the angle is bolted to the
poles/I-beams, all mounting
hardware is the responsibility
of the installer.
2 /
Before the sponsor panel
sections are lifted into place,
attach four 8” mounting
brackets to each 10’ panel
section and four 8” mounting
brackets to the 8’ panel sec-
tion using the supplied 3/8-16
X ¾” bolts, 3/8” flat washers,
and 3/8” hex nuts. The brack-
ets fit inside the panel. The
top (for top-mounted installa-
tions) or the bottom (for bot-
tom-mounted installations) of
each panel is pre-drilled for
the brackets.
NOTE: A flat washer should
be used both on top and on
bottom of the panel, as
hillustrated above
3 /
Lift the first sponsor panel
section into place with the
panel resting on top of the
scoreboard for top-mounted
installations or against the
bottom of the scoreboard
for bottom-mounted in-
stallations, with the face of
the panel flat against the
scoreboards’ front 1-1/2” tall
flange, as shown above.
5 /
Repeat steps 3 & 4 to mount
the remaining sponsor panel
sections.
4 /
Weld or bolt the 8” mounting
brackets (already attached
to the sponsor panel
section) to the mounting
angle, as shown below.
Welding is recommended.
If the mounting brackets are
bolted to the mounting angle
all mounting hardware is the
responsibility of the installer.
6 /
Install the tek screws through
the scoreboards front 1-
1/2” tall flange and into the
sponsor panel face spaced
every foot.
*WELDING IS RECOMMENDED
HARDWARE FOR BOLTING
SUPPLIED BY INSTALLER
10’
10’
