INSTALLATION OVERVIEW
This manual will walk you through the installation of the scoreboard. While care has been taken to
consider the many scenarios for installation, some general information applies to all. Use this guide
as closely as possible to ensure proper installation, as follows:
Review the product specifications below to determine your specific installation hardware.
Determine where to install the scoreboard and install the mounting poles/beams
NOTE:
ALL HARDWARE REQUIRED TO MOUNT THE SCOREBOARD TO POLES OR I BEAMS IS
SUPPLIED BY THE CUSTOMER
.
Arrange scoreboard panels for the assembly process.
Install sponsor panels if applicable.
Install the control cable for cable-controlled systems. No additional installation is necessary
for Wireless Remote Control systems.
Install electrical system.
Install any other options; such as protective nets or horns, according to the installation
instructions included with each option package.
Test the installed system.
PRODUCT SPECIFICATIONS
Overall Dimensions:
8’-0” tall x 20’-0” long x 8” deep; shipped in five (5) sections
Weight:
Hanging weight = approximately 1,800 lbs. - Shipping weight = approximately 1,860 lbs.
Mounting Recommendations:
(2
) 8” steel I-beams (W8 x 31) or (2) 8” OD galvanized steel poles (schedule 40). Total length
determined by local codes, mounting height, and scoreboard options.
Power Requirements:
Scoreboard
(1) 120-volt, 20-amp, 60 Hz grounded AC circuit connected to a power disconnect switch or
circuit breaker (refer to the wiring diagram on page 8 for detailed instructions on determining
the scoreboard’s power requirements – specific power requirement information is also marked
on the scoreboard’s serial number label, located on the scoreboard)
Keyboard Controller
(1) 120-volt, 15-amp, 60 Hz grounded AC circuit in a standard duplex outlet (optional if an
internal battery pack was purchased with the controller or using a handheld controller)
Cable Recommendations (for cable-controlled systems only):
Four conductor cable
– 28 gauge, twisted pair (two pairs), shielded data cable.
