POWX910
EN
Copyright © 2017 VARO
P a g e
|
2
www.varo.com
PIVOTING ARM FOR HOIST
POWX910
1 APPLICATION
The pivoting arm is designed to have one hoist attached to it. The pivoting arm must be
mounted on a well-attached steel rod for this purpose, which has a diameter of 48 mm.
2 DESCRIPTION
1.
Bottom support
2.
Clamping block
3.
2 bolts (M12 x 60 mm)
4.
Upper support
5.
Supporting arm
6.
Cotter pin
7.
Pivoting arm
8.
Large cotter pin
9.
Extension pipe
10. Bolt (M12 x 70 mm)
11. Bolt (M8 x 60 mm)
12. Rubber saddles
3 SYMBOLS
In this manual and/or on the machine the following symbols are used:
Denotes risk of personal injury
or damage to the tool.
Read manual before use.
In accordance with essential applicable safety standards of European
directives.
4 SAFETY WARNINGS
Be sure to take the following points into account, so as to avoid accidents and injury:
Do not overburden the pivoting arm.
In case of damage, do not continue to use the pivoting arm.
For your own safety, make sure that all screws have been properly tightened and check
these regularly.
Always make sure that the cotter pins are properly fastened in the drill holes.
It is strictly forbidden to transport persons with the hoist.
In addition, persons may not stand under the hoist or pivoting arm.
A person that has not been informed about these safety regulations may not use this
product.
All components must be regularly checked for possible deformations or damages.
Always observe the maximum allowed load!
5 ASSEMBLY (FIG. A)
Position of the lower support (1) at the desired working height against a vertical steel tube,
which has a diameter of 48 mm and a wall thickness of at least 4 mm, and which surface
is not too smooth, to ensure a better grip.
Assemble with the clamping block (2) by means of 2 M12 x 60 mm bolts (3) and M12 nuts,
using Ø 12 mm spring washers and Ø 12 mm flat washers, and tighten properly (bolts
must be tightened to 70 Nm minimum).
Install of the upper support (4) and the clamping block (2) in the same manner. Make sure
that they are both installed in the same direction. The distance between both must be 420
mm, measured from the underside to the underside.
Hook one side of the support arm (5) into the hinge pin of the upper support (make sure it
is positioned in the correct direction), and secure it by inserting a cotter pin (6) in the hole
of the hinge pin.
