POWX13302
EN
Copyright © 2015 VARO
P a g i n a
|
9
www.varo.com
7.4.2
Mounting/Replacing the Application Tool/ Accessory
If required, remove an already mounted application tool/accessory.
For removing the application tool/accessory, loosen the screw with the Allen key and
remove the application tool/accessory.
Mount the requested application tool/accessory in such a manner on the tool holder that
the offset faces downward.
Turn the application tool/accessory to a position favourable for the respective job, and
allow it to engage into the cams of the tool holder.
Fasten the application tool/accessory with the bolt. Tighten the bolt with Allen key until the
spring washer of the bolt faces flush against the application tool/accessory.
Check the tight seating of the application tool/accessory. Incorrect or not
securely fastened application tools/accessories can come loose during
operation and pose a hazard.
7.4.3
Mounting/Replacing a Sanding Sheet on the Sanding Plate
The sanding plate is fitted with Hook & loop backing for quick and easy fastening of
sanding sheets with Hook & loop adhesion.
Before attaching the sanding sheet, free the Hook & loop backing of the sanding plate
from any debris by tapping against it in order to enable optimum adhesion.
Position the sanding sheet flush alongside one edge of the sanding plate, then lay the
sanding sheet onto the sanding plate and press firmly.
To remove the sanding sheet, grasp it at one of the tips and pull it off from the sanding
plate.
8 OPERATION
8.1
Switching ON/OFF
Make sure the fully charged battery pack is installed.
Switch the
power tool on: push the ON/OFF switch button forwards to the “0” position.
Switch the power tool off: pull the ON/OFF switch button backwards to the “1” position.
8.2
Adjusting the frequency
Adjust the frequency according to the application before beginning with the work. For example,
we recommend a high frequency for work with the scraper. Conduct a test run in order to find
a suitable frequency.
The frequency controller can be set at 6 positions. The “1”position indicates the lowest
frequency and the“6”position indicates the highest. The operator may have to vary the speed
to optimize cutting efficiency.
