POWX13302
EN
Copyright © 2015 VARO
P a g i n a
|
10
www.varo.com
8.3
Battery capacity indicator (Fig. 1/ pos. 9)
Slide the ON/OFF switch (4) forward. The battery capacity indicator (9) indicates the charging
status of the battery with the help of 3 coloured LEDs.
8.3.1
All LEDs light up:
The battery is fully charged.
8.3.2
Yellow and red LEDs light up:
The battery has enough charge left.
8.3.3
Red LED
The battery is empty, charge the battery.
8.4
LED light (Fig. 1/ pos. 7)
The LED light (7) allows to provide additional illumination for the work area. The LED light (7)
lights up automatically as soon as you press the ON/ OFF switch.
8.5
Working Advice
8.5.1
Sawing
Use undamaged faultless saw blades only. Deformed, blunt saw blades or
saw blades that are otherwise damaged can break.
Plunge cuts may only be applied to soft materials, such as wood, gypsum
plaster boards, etc.!
Before sawing with saw blades in wood, particle board, building materials, etc., check these
for foreign objects such as nails, screws, or similar. If required, remove foreign objects or use
saw blades for metal.
8.5.2
Separating
Note: When separating wall tiles take into consideration that the application tools/accessories
wear heavily when used for longer periods of time.
8.5.3
Sanding
The removal rate and the sanding pattern are primarily determined by the choice of sanding
sheet, the preset oscillation rate and the applied pressure.
Only flawless sanding sheets achieve good sanding capacity and extend the service life of the
machine.
Pay attention to apply uniform sanding pressure; this increases the working life of the sanding
sheets.
Intensifying the sanding pressure does not lead to an increase of the sanding capacity, but to
increased wear of the machine and the sanding sheet.
For precise on-the-spot sanding of edges, corners and hard to reach areas, it is also possible
to work only with the tip or an edge of the sanding plate.
When selectively sanding on the spot, the sanding sheet can heat up considerably. Reduce
the orbital stroke rate and allow the sanding sheet to cool down regularly.
A sanding sheet that has been used for metal should not be used for other materials.
