POWX0481
EN
Copyright © 2019 VARO
P a g e
|
6
www.varo.com
7.4
Using the dust collection box (4)
▪
The dust extraction system extracts sanding dust from the work piece through the holes in
the backing pad. The dust is then transferred through the dust extraction port (5) on the
rear of the sander housing.
▪
To install: pull and slide dust collection box (4) into the dust extraction port (5), make sure
the latches on the right and left of the dust collection box (4) into place and it is secure
before beginning operation.)
▪
To remove: When removing the dust collection box (4), follow the above procedure in
reverse order.
If the dust collection box (4) is full, you can remove it from this tool and open the cover of box,
empty dust, wood bust, etc. in the body, finally clean the dust collection box.
▪
To remove: Hold the top cover (A) with one hand and the lower cover with the other.
Disconnect the top cover form the lower cover. (B)
▪
To install: When assembling the dust collection box, follow the above procedure in reverse
order.
8
TECHNICAL DATA
Rated Voltage
220-240V
Rated Frequency
50Hz
Rated Power
220W
Rotation speed
13000min
-1
Cable length
3m
Sanding surface
80x140x140
мм
Carbon brush motor
Yes
Oscillation speed
26000min
-1
Soft grip
Yes
Hook&loop system
Yes
Self dust function
Yes
9 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
76dB(A)
Acoustic power level LwA
87dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration):
4.2m/s²
K = 1.5 m/s²
10 CLEANING AND MAINTENANCE
▪
The machine does not require any special maintenance.
▪
For safe and efficient working, always keep the machine and the ventilation slots clean.
▪
Always be sure that the tool is switched off and unplugged before carrying out any work on
the tool.
