POWEB2520
EN
Copyright © 2018 VARO
P a g e
|
9
www.varo.com
▪
Tighten the lock lever for depth adjustment.
9.3
Setting the mitre angle (Fig. 5)
The mitre angle is infinitely variable between 0° and 45°.
▪
Loosen the lock lever for angle adjustment (2).
▪
Adjust the shoe to the desired angle between 0° to 45°.
▪
Tighten the lock lever for angle adjustment.
9.4
Mounting the parallel fence (Fig. 6)
The parallel fence allows sawing parallel to an edge at a maximum distance of 10 cm.
▪
Loosen the adjustment screw of guide bar (1).
▪
Slide the guide bar (15) through the slots in the base plate to the desired width.
▪
Tighten the adjusting screw to secure it in the position.
▪
Ensure that the guide bar rests against the wood along its entire length to give consistent
parallel cuts.
10 OPERATION
10.1
Instructions for use
▪
Clamp the workpiece. Make sure that the side which will be visible later is facing down,
because the cut is most accurate at that side.
▪
Switch on the machine before it touches the workpiece. Do not exert pressure on the saw
blade. Allow the machine enough time to cut the workpiece.
▪
Hold the machine with both hands using both grips. This ensures optimum control over the
machine.
▪
For straight cuts along a drawn line use the marking for straight cuts.
▪
For bevel cuts along a drawn line use the marking for bevel cuts.
10.2
Switching on and off (Fig. 7)
Before engage the ON/OFF switch, check that the saw blade is properly
fitted and run smoothly, the blade clamp screw is well tightened.
▪
Connect the battery pack to the cordless circular saw and ensure it firmly.
▪
To switch the tool on, keep the lock-off button (5) depressed and press the on/off switch
(6).
▪
To switch the tool off, release the on/off switch.
10.3
Dust extraction
A vacuum cleaner can be connected to the dust extraction outlet, either directly to the
connector or using an adapter.
▪
If necessary, connect an adapter to the extraction outlet.
11 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
11.1
Cleaning
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
