POWEB2520
EN
Copyright © 2018 VARO
P a g e
|
8
www.varo.com
▪
Solid green + solid red: charged.
Note: if the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery
pack that does not securely fit the charger.
1.
Frequently monitor the charger and battery pack while connected
2.
Unplug the charger and disconnect it from the battery pack when finished.
3.
Allow the battery pack to cool completely before using it.
4.
Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool
down to room temperature before charging. This will extend the life of your
batteries.
8.2
Removal / insertion of battery (Fig. 2)
WARNING: Before making any adjustments ensure the machine is switched
off or remove the battery pack.
▪
Hold the tool with one hand and the battery pack (21) with the other.
▪
To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪
To remove: Press the battery release latch and pull the battery pack out at the same time.
9
ADJUSTMENTS
9.1
Replacing the saw blade (Fig. 3)
Only use sharp and undamaged saw blades. Cracked or bent saw blades must be replaced
immediately.
▪
Place this circular saw on its side on a flat surface. Advice you bring the base plate (10)
down as if a minimum depth cut which is ease to operate.
▪
Push the spindle lock button toward motor housing as the arrow shows in Fig. 3 and firmly
hold it.
▪
Turn the blade clamp bolt clockwise by using the Allen key that supplied with the tool.
▪
Remove the blade clamp bolt and outer flange.
▪
Raise the lower guard (11) by using the lever for lower guard (9), and then remove the
saw blade.
▪
Clean the saw blade flanges, then mount the new saw blade onto the output spindle and
against the inner flange.
▪
Make sure the saw teeth and arrow on the blade is to be the same direction as the arrow
on the lower guard.
▪
Reinstall the outer flange, and tighten the blade clamp bolt.
▪
Make sure that the saw blade runs freely by turning the blade by hand.
9.2
Adjusting the depth of cut (Fig. 4)
The depth of cut is infinitely adjustable. A clean cut is achieved with the saw blade protruding
from the material by approx. 3 mm.
▪
Loosen the lock lever for depth adjustment (16).
▪
Hold the base plate (10) flat against the edge of the work piece and lift the body of the saw
until the blade is at the right depth determined by the depth gauge (17) (align the scale
line).
